Jaguar Binder Foot


1. Before attaching the presser foot, insert the bias tape into the funnel guide to match the tape edge to the guide side.
2. Pull the tape from the rear of the presser foot.
3. Snap on the presser foot.
4. Adjust the needle position so that the needle lines up to the edge of the bias tape.

SKU: JAG010 / 9907 Category:


Jaguar Binder Foot

Attaches bias tape with widths less than 7 mm (1/4 inch) using straight, zigzag or decorative stitches. With a tape guide, this makes attractive binding similar to pre-folded or unfolded bias tape.

Hint: If the needle does not position properly on the bias tape, loosen the position knob on the foot to slide the guide to the left or right.

Shopping Cart

  • No products in the cart.